SPECIFICATION

• 1.one-button operation, automatic shutdown.
• 2.shutdown current is only about 20nA.
• 3.using 8MH crystals.
• 4.can automatically detect NPN, PNP bipolar transistors,
• N-channel and P-channel MOS FET, JFET, diodes, dual diode,
• thyristor small power unidirectional and bidirectional thyristor.
• 5.automatic identification pin arrangement of components.
• 6.current amplification factor and base measuring bipolar
• transistor -. Emitter threshold voltage.
• 7.can be coupled through the base -. Emitter threshold voltage
• and high-current amplification factor identification Darlington
• transistors.
• 8.can detect bipolar transistors and MOS pipe protection diodes.
• 9.measuring MOS FET gate threshold voltage and gate capacitance.
• 10.can be measured simultaneously with two resistors and resistor
• symbol is displayed. Display with four decimal values on the right
• side. Resistance symbol is displayed on both sides of the pin number.
• So you can measure the potentiometer. If the potentiometer wiper
• not be transferred to a extreme position, it can distinguish between
• the middle and both ends of the pin.
• 11.resistance measurement resolution is 0.1 ohm, can measure
• to 50M ohms.
• 12.can be measured capacitance. Capacitor symbol is displayed
• on the right display values can be displayed with four decimal
• value. Can measure the capacitance of 30pF-100mF resolution 1pF.
• 13.2uF more capacitors can measure the value of the equivalent
• series resistance ESR. The two values can be displayed with
• a decimal, resolution of 0.01 ohms.
• 14.may be displayed in the correct order of two diodes and
• a diode symbol, and gives the diode forward voltage.
• 15.LED is detected as a diode, its forward voltage higher.
• LED combo is identified as two diodes.
• 16.Reverse breakdown voltage is less than 4.5V Zene